R&S FSL CALCulate Subsystem (Noise Figure, K30)
1300.2519.12 6.523 E-11
CALCulate Subsystem (Noise Figure, K30)
The CALCulate subsystem checks the marker functions and contains commands for limit lines and their
limit checks.
The following subsystems are included:
• "CALCulate:LIMit Subsystem (Noise Figure, K30)" on page 6.523
• "CALCulate:MARKer Subsystem (Noise Figure, K30)" on page 6.529
CALCulate:LIMit Subsystem (Noise Figure, K30)
The CALCulate:LIMit subsystem contains commands for the limit lines and the corresponding limit
checks. Limit lines can be defined as upper or lower limit lines. The individual y values of the limit lines
correspond to the values of the x–axis (CONTrol). The number of x and y values must be identical. For
details on limit lines refer to chapter "Instrument Functions", section "Using Limit Lines and Display
Lines – LINES Key".
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1 to
LIMIT6).
The following subsystems are included:
• "CALCulate:LIMit:CONTrol Subsystem" on page 6.526
• "CALCulate:LIMit:LOWer Subsystem" on page 6.527
• "CALCulate:LIMit:UPPer Subsystem" on page 6.528
Commands of the CALCulate:LIMit Subsystem
– CALCulate<1|2>:LIMit<1...6>:CLEar[:IMMediate]
– CALCulate<1|2>:LIMit<1...6>:COMMent
– CALCulate<1|2>:LIMit<1...6>:COPY
– CALCulate<1|2>:LIMit<1...6>:DELete
– CALCulate<1|2>:LIMit<1...6>:FAIL?
– CALCulate<1|2>:LIMit<1...6>:NAME
– CALCulate<1|2>:LIMit<1...6>:STATe
– CALCulate<1|2>:LIMit<1...6>:TRACe
CALCulate<1|2>:LIMit<1...6>:CLEar[:IMMediate]
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:CLEar[:IMMediate]" on page 6.29.
CALCulate<1|2>:LIMit<1...6>:COMMent
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:COMMent" on page 6.29.
To Next Page
Loading...
