Rohde & Schwarz R&S FSL3 - Page 1283

CALCulate Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.524 E-11
CALCulate<1|2>:LIMit<1...6>:COPY
Parameter
1 to 6 number of the new limit line
<name> name of the new limit line given as a string (max. 8 alphanumeric characters)
For further details refer to "CALCulate<1|2>:LIMit<1...8>:COPY" on page 6.30.
CALCulate<1|2>:LIMit<1...6>:DELete
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:DELete" on page 6.30.
CALCulate<1|2>:LIMit<1...6>:FAIL?
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:FAIL?" on page 6.31.
CALCulate<1|2>:LIMit<1...6>:NAME
This command assigns a name to a limit line. If it does not exist already, a limit line with this
name is created.
The numeric suffixes <1...6> indicate the limit line.
Parameter
<name of limit line>, max. 8 alphanumeric characters
Example
CALC:LIM1:NAME FM1
Assigns the name FM1 to limit line 1.
Characteristics
*RST value: REM1 to REM6 for lines 1 to 6
SCPI: device–specific
Mode
NF
CALCulate<1|2>:LIMit<1...6>:STATe
Different to the base unit, only 6 limit lines can be active at the same time (indicated by LIMIT1
to LIMIT6).
For further details refer to "CALCulate<1|2>:LIMit<1...8>:STATe" on page 6.31.