Rohde & Schwarz R&S FSL3 - Page 790

R&S FSL CALCulate Subsystem
1300.2519.12 6.31 E-11
CALCulate<1|2>:LIMit<1...8>:FAIL?
This command queries the result of the limit check of the indicated limit line. It should be noted
that a complete sweep must have been performed to obtain a correct result. A synchronization
with *OPC, *OPC? or *WAI should therefore be provided. The result of the limit check is given
with 0 for PASS, 1 for FAIL, and 2 for MARGIN.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Return values
0 for pass, 1 for fail
Example
INIT;*WAI
Starts a new sweep and waits for its end.
CALC:LIM3:FAIL?
Queries the result of the check for limit line 3.
Characteristics
*RST value: –
SCPI: conform
Mode
A, ADEMOD, NF, CDMA, EVDO, WLAN
CALCulate<1|2>:LIMit<1...8>:NAME
This command assigns a name to a limit line numbered 1 to 8. If it does not exist already, a limit
line with this name is created.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
<name of limit line>
Example
CALC:LIM1:NAME 'FM1'
Assigns the name FM1 to limit line 1.
Characteristics
*RST value: REM1 to REM8 for lines 1 to 8
SCPI: device–specific
Mode
A, ADEMOD, CDMA, EVDO
CALCulate<1|2>:LIMit<1...8>:STATe
This command switches on or off the limit check for the selected limit line.
The result of the limit check can be queried with CALCulate<1|2>:LIMit<1...8>:FAIL?.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
ON | OFF