Rohde & Schwarz R&S FSL3 - Display Subsystem (BLUETOOTH, K8)

R&S FSL DISPlay Subsystem (BLUETOOTH, K8)
1300.2519.12 6.369 E-11
DISPlay Subsystem (BLUETOOTH, K8)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
Commands of the DISPlay Subsystem
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:PDIVision
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RVALue
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:PDIVision
This command defines the scaling of the y–axis in the currently selected unit. The numeric suffix
in TRACe<1...6> is irrelevant.
Parameter
<numeric_value>
Example
DISP:TRAC:Y:PDIV 10kHz
Sets the Y scale to 10 kHz/div.
Characteristics
*RST value: –
SCPI: conform
Mode
BT
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
This command defines the position of the reference value. In Bluetooth mode, the selected
reference position is valid for all measurements.
Characteristics
*RST value: 50 PCT
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
(models with tracking generator)" on page 6.136.
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RVALue
This command defines the result value assigned to the reference position on the graticule.
Example
DISP:TRAC:Y:RVAL 0
Sets the value assigned to the reference position to 0 Hz
Characteristics
*RST value: 0 Hz
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
(models with tracking generator)" on page 6.136.