CONFigure:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.368 E-11
Characteristics
*RST value: WRITe
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:TRACe<1...6>:SELect
This command selects the measurement curve for evaluation of the modulation characteristics.
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
INIT:CONT OFF
Selects single sweep operation.
CONF:BTO:TRAC2:SEL
Selects trace 2 for measurement result queries.
Characteristics
*RST value: –
SCPI: device–specific
Mode
BT
To Next Page
Loading...
