R&S FSL Instrument Functions – Analyzer
1300.2519.12 4.1 E-11
Instrument Functions – Analyzer
I
n this section, all analyzer functions of the R&S FSL and their application are explained in detail. The
basic settings functions are described in section "Instrument Functions – Basic Settings".
For every key a table is provided in which all submenus and corresponding commands are listed. The
description of the submenus and commands follows the order of the table. The commands for the
optional remote control (if any) are indicated for each softkey. The description is divided into the
following topics:
• "Measurement Parameters" on page 4.2
This section describes how to reset the instrument, to set up specific measurements and to set the
measurement parameters. Examples of basic operations are provided in the Quick Start Guide,
chapter 5 "Basic Measurement Examples". Advanced examples are described in chapter
"Advanced Measurement Examples".
• "Measurement Functions" on page 4.52
This section informs about how to select and configure the measurement functions. Examples of
basic operations are provided in the Quick Start Guide, chapter 5 "Basic Measurement Examples".
Advanced examples are described in chapter "Advanced Measurement Examples".
• "Measurement Modes" on page 4.128
This section describes the provided measurement modes, the change of measurement modes and
the access to the menus of all active measurement modes.
• "Models and Options" on page 4.133
This section informs about optional functions and their application that are included in the basic unit
configuration.
More basic information on operation is given in the Quick Start Guide. The front and the rear view of the
instrument together with a table of all available keys and a short description are provided in chapter
"Front and Rear Panel". Chapter "Preparing for Use" informs how to start working with the instrument
for the first time. A brief introduction on handling the instrument is given in chapter "Basic Operations".
This includes also the description of the keys for basic operations like switching the instrument on and
off or starting a measurement.
To Next Page
Loading...
