Rohde & Schwarz R&S FSL3 - Display Subsystem (WLAN, K91; K91 N)

R&S FSL DISPlay Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.709 E-11
DISPlay Subsystem (WLAN, K91 / K91n)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display. In contrast to the base unit, the WLAN TX Measurements
option supports the split screen modus.
Commands of the DISPlay Subsystem
– DISPlay:FORMat
– DISPlay[:WINDow<1|2>]:SSELect
– DISPlay[:WINDow<1|2>]:TABLe
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:AUTO
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:PDIVision
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:RLEVel
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:RLEVel:OFFSet
DISPlay:FORMat
This command sets the visible screen display type to full or split screen.
Parameter
SPLit | SINGle
Example
DISP:FORM SINGle
Sets the display to full screen.
Characteristics
*RST value: SPL
SCPI: device–specific
Mode
WLAN
DISPlay[:WINDow<1|2>]:SSELect
This command selects whether screen A or screen B is active. SSELect means Screen SELect.
Example
DISP:WIND1:SSEL
Sets the screen A active.
Characteristics
*RST value: 1
SCPI: device–specific
Mode
WLAN