DISPlay Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.710 E-11
DISPlay[:WINDow<1|2>]:TABLe
This command selects whether the results table is displayed.
Parameter
ON | OFF
Example
DISP:WIND1:TABL ON
Hides the results table
Characteristics
*RST value: ON
SCPI: device–specific
Mode
WLAN
DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:AUTO
This command switches on or off automatic scaling of the Y–axis for the specified trace display.
Automatic scaling sets the Y–axis to automatically scale to best fit the measurement results.
This command is only available for the following result displays:
– EVM vs Carrier
– EVM vs Symbol.
– Frequency error vs Preamble
– Phase error vs Preamble
The numeric suffix at WINDow<1|2> must be 2 as the relevant results are always displayed in
screen B. The numeric suffix at TRACe<1...3> must be 1.
Parameter
ON | OFF
Example
DISP:WIND2:TRAC:Y:SCAL:AUTO ON
switches on automatic scaling of the Y–axis for the active trace
Characteristics
*RST value: ON
Mode
WLAN
DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:PDIVision
This command sets the size of each Y scale division for the specified trace display. Note that
this command has no affect if automatic scaling of the Y–axis is enabled. This command is only
available for the following result displays:
– EVM vs Carrier
– EVM vs Symbol.
– Frequency error vs Preamble
– Phase error vs Preamble
To Next Page
Loading...
