Rohde & Schwarz R&S FSL3 - Configuring the Sweep Mode - SWEEP Key

Configuring the Sweep Mode – SWEEP Key R&S FSL
1300.2519.12 4.24 E-11
Configuring the Sweep Mode – SWEEP Key
The SWEEP key is used to configure the sweep mode. Continuous sweep or single sweep are
possible. The sweep time and the number of measured values are set.
To open the sweep menu
 Press the SWEEP key.
The sweep menu is displayed.
Menu and softkey description
– "Softkeys of the sweep menu" on page 4.25
To display help to a softkey, press the HELP key and then the softkey for which you want to display
help. To close the help window, press the ESC key. For further information refer to section "How to use
the Help System".
Task
– To specify the sweep settings