R&S FSL Configuring the Sweep Mode – SWEEP Key
1300.2519.12 4.25 E-11
To specify the sweep settings
1. Press the Sweep Count softkey and enter the sweep count.
2. Set the sweep time by using the Sweeptime Manual or Sweeptime Auto softkey.
3. Press the Sweep Points softkey and enter the number of sweep points.
4. Select the sweep mode using the Continuous Sweep or Single Sweep softkey.
5. To repeat the single sweep, press the Continue Single Sweep softkey.
Softkeys of the sweep menu
The following table shows all softkeys available in the sweep menu. It is possible that your instrument
configuration does not provide all softkeys. If a softkey is only available with a special option, model or
(measurement) mode, this information is delivered in the corresponding softkey description.
If the Spectrogram Measurement option (K14) is activated, this menu provides additional functionality.
For details refer to "Softkeys of the sweep menu (Spectrogram view)" on page 4.195.
Command
Continuous Sweep
Single Sweep
Continue Single Sweep
Sweeptime Manual
Sweeptime Auto
Sweep Count
Sweep Points
Continuous Sweep
Sets the continuous sweep mode: the sweep takes place continuously according to the trigger
settings. This is the default setting. The trace averaging is determined by the sweep count value
(see Sweep Count softkey).
If the Spectrogram Measurement option (K14) is activated, this softkey provides additional
functionality. For details refer to Continuous Sweep Start/Stop softkey in the sweep menu of
this option.
Remote: INIT:CONT ON
Single Sweep
Sets the single sweep mode: after triggering, starts the number of sweeps that are defined by
using the Sweep Count softkey. The measurement stops after the defined number of sweeps
has been performed.
Remote: INIT:CONT OFF
To Next Page
Loading...
