R&S FSL Spectrogram Measurement (Option K14)
1300.2519.12 4.195 E-11
Time Stamp On/Off
Defines the displayed item in the right lower corner.
On
The time stamp (system time of the sweep start) is displayed instead of the frame
number.
Off
The frame number is displayed.
Remote: CALC:SPEC:TST ON
Softkeys of the sweep menu (Spectrogram view)
The following table shows all softkeys available in the sweep menu of the Spectrogram Measurement
option (SWEEP key). It is possible that your instrument configuration does not provide all softkeys. If a
softkey is only available with a special option, model or (measurement) mode, this information is
delivered in the corresponding softkey description.
Command
Continuous Sweep Start/Stop
Single Sweep
Select Frame
Sweeptime Manual
Sweeptime Auto
Sweep Count
More
Sweep Points
Continue Frame On/Off
Frame Count
Spectrogram Clear
Continuous Sweep Start/Stop
Stops or continues the measurement in continuous sweep mode. The trace averaging is
determined by the sweep count value (for details refer to the Sweep Count softkey in the trace
menu of the base unit).
Continuous Sweep Start
The measurement is stopped. Press the softkey to continue the
measurement.
Continuous Sweep Stop
The measurement is running. Press the softkey to stop the
measurement.
Remote: INIT:CONT ON
Single Sweep
For details refer to the Single Sweep softkey in the sweep menu of the base unit.
To Next Page
Loading...
