R&S FSL CALCulate Subsystem (CDMA, K82)
1300.2519.12 6.597 E-11
CALCulate Subsystem (CDMA, K82)
The CALCulate subsystem contains commands for converting instrument data, transforming and
carrying out corrections. These functions are carried out subsequent to data acquisition, i.e. following
the SENSe subsystem.
The following subsystems are included:
• "CALCulate:FEED Subsystem (CDMA, K82)" on page 6.597
• "CALCulate:LIMit:ESPectrum Subsystem (CDMA, K82)" on page 6.599
• "CALCulate:MARKer<1…4>:FUNCtion Subsystem (CDMA, K82)" on page 6.601
• "CALCulate:STATistics Subsystem (CDMA, K82)" on page 6.603
CALCulate:FEED Subsystem (CDMA, K82)
The CALCulate:FEED subsystem selects the type of evaluation for the measurement data. This
corresponds to the result display selection in manual operation.
Commands of the CALCulate:FEED Subsystem
– CALCulate<1|2>:FEED
CALCulate<1|2>:FEED
This command selects the result display for the measured data.The numeric suffix at
CALCulate<1|2> specifies the measurement window.
Parameter
XPOW:CDP Code Domain Power (CDP) result display (absolute)
XPOW:CDP:RAT Code Domain Power (CDP) result display (relative)
XPOW:CDEP Code Domain Error Power (CDEP) result display
XTIM:CDP:ERR:CTABle Channel Table result display
XTIM:CDP:PVSLot Power versus Power Control Group (PCG) result display
XTIM:CDP:ERR:SUMM Result Summary result display
XTIM:CDP:MACCuracy Composite EVM result display
XTIM:CDP:ERR:PCDomain Peak Code Domain Error result display
XTIM:CDP:SYMB:CONSt Channel Constellation result display
XTIM:CDP:SYMB:EVM Symbol Error Vector Magnitude result display
XTIM:CDP:BSTReam Channel Bitstream result display
XTIM:CDP:COMP:CONSt Composite Constellation result display
XTIM:CDP:PVSYmbol Power versus Symbol result display
To Next Page
Loading...
