Rohde & Schwarz R&S FSL3 - Measurement Parameters

Measurement Parameters R&S FSL
1300.2519.12 4.2 E-11
Measurement Parameters
In this section all menus necessary for setting measurement parameters are described. This includes
the following topics and keys. For details on changing the mode refer to "Measurement Mode Selection
– MODE Key" on page 4.129.
• "Initializing the Configuration – PRESET Key" on page 4.3
• "Selecting the Frequency and Span – FREQ Key" on page 4.5
• "Setting the Frequency Span – SPAN Key" on page 4.11
• "Setting the Level Display and Configuring the RF Input – AMPT Key" on page 4.13
• "Setting the Bandwidths and Sweep Time – BW Key" on page 4.18
• "Configuring the Sweep Mode – SWEEP Key" on page 4.24
• "Triggering the Sweep – TRIG Key" on page 4.28
• "Setting Traces – TRACE Key" on page 4.39
Table 4-1: Sweep range variables
Abbreviation Definition R&S FSL3
value
R&S FSL6
value
R&S FSL18
value
f
max
max. frequency 3 GHz 6 GHz 18 GHz*
f
min
min. frequency available 0 Hz 0 Hz 0 Hz
span
min
smallest selectable span > 0 Hz 10 Hz 10 Hz 10 Hz
* In remote control, the query of the maximum frequency returns 20 GHz. For further details refer to
chapter 6.