R&S FSL Advanced Measurement Examples
1300.2519.12 2.1 E-11
2 Advanced Measurement Examples
This chapter explains how to operate the R&S FSL using typical measurements as examples.
Additional background information on the settings is given. Examples of more basic character are
provided in the Quick Start Guide, chapter 5, as an introduction. The following topics are included in the
Quick Start Guide:
• Performing a Level and Frequency Meaurement
• Measuring a Sinusoidal Signal
Measuring the Level and Frequency Using Markers
Measuring the Signal Frequency Using the Frequency Counter
• Measuring Harmonics of Sinusoidal Signals
Measuring the Suppression of the First and Second Harmonic of an Input Signal
• Measuring Signal Spectra with Multiple Signals
Separating Signals by Selecting the Resolution Bandwidth
Measuring the Modulation Depth of an AM–Modulated Carrier (Span > 0)
Measuring of AM–Modulated Signals
• Measurements with Zero Span
Measuring the Power Characteristic of Burst Signals
Measuring the Signal–to–Noise Ratio of Burst Signals
Measurement of FM–Modulated Signals
• Storing and Loading Instrument Settings
Storing an Instrument Configuration (without Traces)
Storing Traces
Loading an Instrument Configuration (with Traces)
Configuring Automatic Loading
To Next Page
Loading...
