R&S FSL Notation
1300.2519.12 6.2 E-11
Notation
In the following sections, all commands implemented in the instrument are first listed and then
described in detail, arranged according to the command subsystems. The notation is adapted to the
SCPI standard. The SCPI conformity information is included in the individual description of the
commands.
• Individual Description
• Upper/Lower Case Notation
• Special Characters
• Description of Parameters
Individual Description
The individual description contains the complete notation of the command. An example for each
command, the *RST value and the SCPI information are included as well.
The options and operating modes for which a command can be used are indicated by the following
abbreviations:
Abbreviation Description
A spectrum analysis
A–F spectrum analysis – span > 0 only (frequency mode)
A–T spectrum analysis – zero span only (time mode)
ADEMOD analog demodulation (option R&S FSL–K7)
BT Bluetooth measurements (option R&S FSL–K8)
CATV cable TV measurements (option R&S FSL–K20)
CDMA CDMA2000 Base Station measurements (option R&S FSL-K82)
NF noise figure measurements (option R&S FSL–K30)
OFDM WiMAX IEEE 802.16 OFDM measurements
(options R&S FSL–K92/K93)
OFDMA/WiBro WiMAX IEEE 802.16e OFDMA/WiBro measurements
(option R&S FSL–K93)
PSM power sensor measurements (option R&S FSL–K9)
SPECM spectrogram measurements (option R&S FSL–K14)
WCDMA 3GPP Base Station measurements (option R&S FSL–K72)
WLAN WLAN TX measurements (option R&S FSL–K91)
Note: The spectrum analysis (analyzer) mode is implemented in the basic unit. For the other modes,
the corresponding options are required.
Upper/Lower Case Notation
Upper/lower case letters are used to mark the long or short form of the key words of a command in the
description (see chapter 5 "Remote Control – Basics"). The instrument itself does not distinguish
between upper and lower case letters.
To Next Page
Loading...
