Rohde & Schwarz R&S FSL3 - READ Subsystem (Power Meter, K9)

READ Subsystem (Power Meter, K9) R&S FSL
1300.2519.12 6.382 E-11
READ Subsystem (Power Meter, K9)
The READ subsystem contains commands for starting complex measurement tasks, and for querying
the results subsequently.
The following subsystem is included:
• "READ:PMETer Subsystem" on page 6.382
READ:PMETer Subsystem
This subsystem contains commands to start power sensor measurements and to read the results after
the measurement is concluded.
Commands of the READ:PMETer Subsystem
– READ<1|2>:PMETer?
READ<1|2>:PMETer?
This command starts a power sensor measurement and reads the result after the measurement
is concluded.
This command is a query and therefore has no *RST value.
Example
READ:PMET?
Starts a measurement and read the result.
Characteristics
*RST value: –
SCPI: device–specific
Mode
PSM