Rohde & Schwarz R&S FSL3 - Display Subsystem (Analog Demodulation, K7)

R&S FSL DISPlay Subsystem (Analog Demodulation, K7)
1300.2519.12 6.295 E-11
DISPlay Subsystem (Analog Demodulation, K7)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
Commands of the DISPlay Subsystem
– DISPlay[:WINDow<1|2>]:SIZE
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:PDIVision
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RVALue
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y:SPACing
DISPlay[:WINDow<1|2>]:SIZE
This command switches the measurement window for active analog demodulation to full screen
or half screen.
For further details refer to "DISPlay[:WINDow<1|2>]:SIZE" on page 6.130.
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:PDIVision
This command defines the scaling of the y–axis in the current unit. The numeric suffix in
TRACe<1...6> is irrelevant. The numeric suffixes <1|2> are irrelevant.
Parameter
<numeric_value>
Example
DISP:TRAC:Y:PDIV +10kHz
Sets the Y scale to 10 kHz/div.
Characteristics
*RST value:
20 PCT linear AM display
50 kHz linear FM display
2 rad linear PM display
10 dB logarithmic AF spectrum display
SCPI: conform
Mode
ADEMOD