Rohde & Schwarz R&S FSL3 - UNIT Subsystem (Power Meter, K9)

UNIT Subsystem (Power Meter, K9) R&S FSL
1300.2519.12 6.388 E-11
UNIT Subsystem (Power Meter, K9)
The UNIT subsystem sets the basic unit of the setting parameters.
The following subsystems are included:
• "UNIT:PMETer Subsystem (Power Meter, K9)" on page 6.388
UNIT:PMETer Subsystem (Power Meter, K9)
The UNIT:PMETer subsystem sets the basic unit for power sensor measurement.
Commands of the UNIT:PMETer Subsystem
– UNIT<1|2>:PMETer:POWer
– UNIT<1|2>:PMETer:POWer:RATio
UNIT<1|2>:PMETer:POWer
This command selects the unit for absolute power sensor measurement.
Parameter
DBM | WATT | W
Example
UNIT:PMET:POW DBM
Characteristics
*RST value: DBM
SCPI: conform
Mode
PSM
UNIT<1|2>:PMETer:POWer:RATio
This command selects the unit for relative power sensor measurement.
Parameter
DB | PCT
Example
UNIT:PMET:POW DB
Characteristics
*RST value: DB
SCPI: conform
Mode
PSM