SYSTem Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.564 E-11
Remote Commands of the 3GPP Base Station
Measurements Option (K72)
This section describes the remote commands for the 3GPP Base Station Measurements option (K72).
The abbreviation WCDMA stands for the operating mode of this option. For details on conventions used
in this chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in section "Remote Commands of the Base Unit" on page 6.5.
This option is available from firmware version 1.60.
Subsystems of the 3GPP Base Station Measurements option (K72)
– "ABORt Subsystem (WCDMA, K72)" on page 6.565
– "CALCulate Subsystem (WCDMA, K72)" on page 6.566
– "CONFigure:WCDPower Subsystem (WCDMA, K72)" on page 6.576
– "DISPlay Subsystem (WCDMA, K72)" on page 6.577
– "INITiate Subsystem (WCDMA, K72)" on page 6.579
– "INPut Subsystem (WCDMA, K72)" on page 6.580
– "INSTrument Subsystem (WCDMA, K72)" on page 6.581
– "SENSe Subsystem (WCDMA, K72)" on page 6.582
– "STATus:QUEStionable Subsystem (WCDMA, K72)" on page 6.591
– "TRACe Subsystem (WCDMA, K72)" on page 6.592
– "TRIGger Subsystem (WCDMA, K72)" on page 6.595
To Next Page
Loading...
