R&S FSL STATus Subsystem
1300.2519.12 6.237 E-11
STATus Subsystem
The STATus subsystem contains the commands for the status reporting system (for details refer to
chapter 5 "Remote Control – Basics", section "Status Reporting System"). *RST does not influence the
status registers.
The following subsystem is included:
• "STATus:QUEStionable Subsystem" on page 6.239
Commands of the STATus subsystem
– STATus:OPERation[:EVENt]?
– STATus:OPERation:CONDition?
– STATus:OPERation:ENABle
– STATus:OPERation:PTRansition
– STATus:OPERation:NTRansition
– STATus:PRESet
STATus:OPERation[:EVENt]?
This command queries the contents of the EVENt section of the STATus:OPERation register.
The contents of the EVENt section are deleted after readout.
Example
STAT:OPER?
Characteristics
*RST value: -
SCPI: conform
Mode
all
STATus:OPERation:CONDition?
This command queries the CONDition section of the STATus:OPERation register. Readout
does not delete the contents of the CONDition section. The value returned reflects the current
hardware status.
Example
STAT:OPER:COND?
Characteristics
*RST value: -
SCPI: conform
Mode
all
To Next Page
Loading...
