Rohde & Schwarz R&S FSL3 - Page 998

R&S FSL STATus Subsystem
1300.2519.12 6.239 E-11
STATus:PRESet
This command resets the edge detectors and ENABle parts of all registers to a defined value.
All PTRansition parts are set to FFFFh, i.e. all transitions from 0 to 1 are detected. All
NTRansition parts are set to 0, i.e. a transition from 1 to 0 in a CONDition bit is not detected.
The ENABle part of the STATus:OPERation and STATus:QUEStionable registers are set to 0,
i.e. all events in these registers are not passed on.
Example
STAT:PRES
Characteristics
*RST value: -
SCPI: conform
Mode
all
STATus:QUEStionable Subsystem
The STATus:QUEStionable subsystem contains information about the observance of limits during
adjacent power measurements, the reference and local oscillator, the observance of limit lines and limit
margins and possible overloads of the unit.
Commands of the STATus:QUEStionable Subsystem
– STATus:QUEStionable[:EVENt]?
– STATus:QUEStionable:CONDition?
– STATus:QUEStionable:ENABle
– STATus:QUEStionable:PTRansition
– STATus:QUEStionable:NTRansition
– STATus:QUEStionable:ACPLimit[:EVENt]?
– STATus:QUEStionable:ACPLimit:CONDition?
– STATus:QUEStionable:ACPLimit:ENABle
– STATus:QUEStionable:ACPLimit:NTRansition
– STATus:QUEStionable:ACPLimit:PTRansition
– STATus:QUEStionable:FREQuency[:EVENt]?
– STATus:QUEStionable:FREQuency:CONDition?
– STATus:QUEStionable:FREQuency:ENABle
– STATus:QUEStionable:FREQuency:NTRansition
– STATus:QUEStionable:FREQuency:PTRansition
– STATus:QUEStionable:LIMit<1|2>[:EVENt]?
– STATus:QUEStionable:LIMit<1|2>:CONDition?
– STATus:QUEStionable:LIMit<1|2>:ENABle
– STATus:QUEStionable:LIMit<1|2>:NTRansition
– STATus:QUEStionable:LIMit<1|2>:PTRansition
– STATus:QUEStionable:LMARgin<1|2>[:EVENt]?