Rohde & Schwarz R&S FSL3 - Page 1006

R&S FSL STATus Subsystem
1300.2519.12 6.247 E-11
STATus:QUEStionable:LIMit<1|2>:PTRansition
This command sets the edge detectors of all bits of the STATus:QUEStionable:LIMit register
from 0 to 1 for the transitions of the CONDition bit.
This command is available from firmware version 1.10.
Parameter
0 to 65535
Example
STAT:QUES:LIM:PTR 65535
Characteristics
*RST value: –
SCPI: device–specific
Mode
all, except NF
STATus:QUEStionable:LMARgin<1|2>[:EVENt]?
This command queries the contents of the EVENt section of the
STATus:QUEStionable:LMARgin register. Readout deletes the contents of the EVENt section.
Example
STAT:QUES:LMAR?
Characteristics
*RST value: –
SCPI: device–specific
Mode
all
STATus:QUEStionable:LMARgin<1|2>:CONDition?
This command queries the contents of the CONDition section of the
STATus:QUEStionable:LMARgin register. Readout does not delete the contents of the
CONDition section.
Example
STAT:QUES:LMAR:COND?
Characteristics
*RST value: –
SCPI: device–specific
Mode
all