Rohde & Schwarz R&S FSL3 - Page 1005

STATus Subsystem R&S FSL
1300.2519.12 6.246 E-11
S
TATus:QUEStionable:LIMit<1|2>:CONDition?
This command queries the contents of the CONDition section of the
STATus:QUEStionable:LIMit register.
Readout does not delete the contents of the CONDition section.
This command is available from firmware version 1.10.
Example
STAT:QUES:LIM:COND?
Characteristics
*RST value: –
SCPI: device–specific
Mode
all
STATus:QUEStionable:LIMit<1|2>:ENABle
This command sets the bits of the ENABle section of the STATus:QUEStionable register. The
ENABle register selectively enables the individual events of the associated EVENt section for
the summary bit.
This command is available from firmware version 1.10.
Parameter
0 to 65535
Example
STAT:QUES:LIM:ENAB 65535
Characteristics
*RST value: –
SCPI: device–specific
Mode
all
STATus:QUEStionable:LIMit<1|2>:NTRansition
This command sets the edge detectors of all bits of the STATus:QUEStionable:LIMit register
from 1 to 0 for the transitions of the CONDition bit.
This command is available from firmware version 1.10.
Parameter
0 to 65535
Example
STAT:QUES:LIM:NTR 65535
Characteristics
*RST value: –
SCPI: device–specific
Mode
all, except NF