Remote Commands of the CDMA2000 BTS Analyzer Option (K82) R&S FSL
1300.2519.12 6.596 E-11
Remote Commands of the CDMA2000 BTS Analyzer
Option (K82)
This chapter describes the remote commands for the CDMA2000 BTS Analyzer option (K82). The
abbreviation CDMA stands for the operating mode of this option. For details on conventions used in this
chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in "Remote Commands of the Base Unit" on page 6.5.
This option is available from firmware version 1.90.
Subsystems of the CDMA2000 BTS Analyzer option (K82)
– "CALCulate Subsystem (CDMA, K82)" on page 6.597
– "CONFigure Subsystem (CDMA, K82)" on page 6.604
– "DISPlay Subsystem (CDMA, K82)" on page 6.611
– "INSTrument Subsystem (CDMA, K82)" on page 6.613
– "SENSe Subsystem (CDMA, K82)" on page 6.614
– "TRACe Subsystem (CDMA, K82)" on page 6.624
To Next Page
Loading...
