Bluetooth Measurements (Option K8) R&S FSL
1300.2519.12 4.158 E-11
Bluetooth Measurements (Option K8)
This option provides measurements to test the conformity of signal sources to the Bluetooth RF Test
Specification (Bluetooth SIG). For background information on Bluetooth measurements refer to chapter
"Advanced Measurement Examples".
This option is available from firmware version 1.30.
To open the Bluetooth menu
If the Bluetooth mode is not the active measurement mode, press the MODE key and activate the
Bluetooth option.
If the Bluetooth mode is already active, press the MENU key.
The Bluetooth menu is displayed. .
Menu and softkey description
– "Softkeys of the Bluetooth menu" on page 4.167
– "Softkeys of the frequency menu (Bluetooth mode)" on page 4.172
– "Softkeys of the amplitude menu (Bluetooth mode)" on page 4.173
– "Softkeys of the bandwidth menu (Bluetooth mode)" on page 4.175
– "Softkeys of the sweep menu (Bluetooth mode)" on page 4.177
– "Softkeys of the trigger menu (Bluetooth mode)" on page 4.180
– "Softkeys of the measurement menu (Bluetooth mode)" on page 4.181
The span menu is not available in the Bluetooth mode. All other menus are provided as described for
the base unit. For details refer to the corresponding menu descriptions.
To display help to a softkey, press the HELP key and then the softkey for which you want to display
help. To close the help window, press the ESC key. For further information refer to section "How to use
the Help System".
Further information
– "Position of a Bluetooth burst" on page 4.160
– "Labels used in the measurement displays" on page 4.161
Tasks
– To adapt the settings to the characteristics of the DUT
To Next Page
Loading...
