R&S FSL Bluetooth Measurements (Option K8)
1300.2519.12 4.175 E-11
Softkeys of the bandwidth menu (Bluetooth mode)
T
he following table shows all softkeys available in the bandwidth menu in Bluetooth mode (BW key). It
is possible that your instrument configuration does not provide all softkeys. If a softkey is only available
with a special option, model or (measurement) mode, this information is delivered in the corresponding
softkey description.
Command
Meas Time Manual
Meas Time Auto
Sweeptime Manual
Sweeptime Auto
Res BW Manual
Res BW Auto
Video BW Manual
Video BW Auto
Filter Type
Meas Filter
Meas Time Manual
(Output Power, Modulation Char, Init Carr Freq Tol, Carr Freq Drift, Rel TX Power, Carr Freq
Stability, Diff Phase)
Opens an edit dialog box to enter the measurement time. The valid value range is 1 µs to
(400001 / points per symbol) µs.
Remote: CONF:BTO:SWE:TIME 10MS
Meas Time Auto
(Output Power, Modulation Char, Init Carr Freq Tol, Carr Freq Drift, Rel TX Power, Carr Freq
Stability, Diff Phase)
Activates the automatic calculation of the measurement time. The automatic sweep time
corresponds to the settings defined in the RF Test Specification. By default, the automatic
sweep time calculation is activated.
Remote: CONF:BTO:SWE:TIME:AUTO ON
Sweeptime Manual (TX Spec ACP)
Opens an edit dialog box to enter the sweep time. The valid value range is 10 µs (minimum
measurement time for one channel) to 16000 s. The default setting is 79 s.
Remote: CONF:BTO:SWE:TIME 10MS
Sweeptime Auto (TX Spec ACP)
Activates the automatic calculation of the sweep time. The automatic sweep time corresponds to
the settings defined in the RF Test Specification. By default, it is activated.
Remote: CONF:BTO:SWE:TIME:AUTO ON
To Next Page
Loading...
