Bluetooth Measurements (Option K8) R&S FSL
1300.2519.12 4.174 E-11
Reference Value (Modulation Char, Init Carr Freq Tol, Carr Freq Drift)
Opens an edit dialog box to enter the FM deviation at the reference line on the y–axis. This
allows individual frequency offsets to be taken into account for the display of the measurement
curves. The valid value range is 0 to
1 MHz; the default setting is 0 Hz.
Remote: DISP:TRAC:Y:RVAL 0
Range Log
(Output Power, TX Spec ACP, Rel TX Power, Spurious Emissions, Carr Freq Stability, Diff Phase)
For details refer to the Range Log softkey in the amplitude menu of the base unit.
Range Linear
(Output Power, TX Spec ACP, Rel TX Power, Spurious Emissions, Carr Freq Stability, Diff Phase)
For details refer to the Range Linear softkey in the amplitude menu of the base unit.
RF Atten Manual
For details refer to the RF Atten Manual softkey in the amplitude menu of the base unit.
RF Atten Auto
For details refer to the RF Atten Auto softkey in the amplitude menu of the base unit.
Ref Level Offset
For details refer to the Ref Level Offset softkey in the amplitude menu of the base unit.
Ref Level Position
For details refer to the Ref Level Position softkey in the amplitude menu of the base unit.
Input 50 D / 75 D
For details refer to the Input 50 D / 75 D softkey in the amplitude menu of the base unit.
To Next Page
Loading...
