Rohde & Schwarz R&S FSL3 - Page 358

R&S FSL Bluetooth Measurements (Option K8)
1300.2519.12 4.173 E-11
Softkeys of the amplitude menu (Bluetooth mode)
The following table shows all softkeys available in the amplitude menu in Bluetooth mode (AMPT key).
It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or (measurement) mode, this information is delivered in the
corresponding softkey description.
Menu / Command Command
Ref Level
Range  Range
Reference Position
Reference Value
Zoom
Range Log
Range Linear
RF Atten Manual
RF Atten Auto
More 
Ref Level Offset
Ref Level Position
Input 50 L / 75 L
Ref Level
The maximum input power of the A/D converter (defined by this value) must be equal or higher
than the maximum power of the signal under test.
For details refer to the Ref Level softkey in the amplitude menu of the base unit.
Range (Modulation Char, Init Carr Freq Tol, Carr Freq Drift)
Opens a submenu for scaling the x– and y–axis.
Range (Modulation Char, Init Carr Freq Tol, Carr Freq Drift)
Opens an edit dialog box to enter the range for the frequency deviation.
 Remote: DISP:TRAC:Y 110dB
Reference Position (Modulation Char, Init Carr Freq Tol, Carr Freq Drift)
Opens an edit dialog box to enter the position of the reference line for the frequency deviation on
the y–axis of the diagram. The unit is % of the diagram height, with 100% corresponding to the
upper diagram border.
 Remote: DISP:WIND:TRAC:Y:RPOS 50PCT