R&S FSL Setting Traces – TRACE Key
1300.2519.12 4.39 E-11
Setting Traces – TRACE Key
The TRACE key is used to configure the data acquisition for measurement and the analysis of the
measurement data.
The R&S FSL is capable of displaying up to six different traces at a time in a diagram. A trace consists
of a maximum of 501 measurement points on the horizontal axis (frequency or time). If more measured
values than measurement points are available, several measured values are combined in one
measurement point.
The trace functions are subdivided as follows:
• Display mode of trace (Clear Write, View and Blank). For details on trace modes see "Trace mode
overview" on page 4.40.
• Evaluation of the trace as a whole (Average, Max Hold and Min Hold). For details on trace modes
see "Trace mode overview" on page 4.40. For details on averaging see "Description of the
averaging method" on page 4.41.
• Evaluation of individual measurement points of a trace. For details on detectors see "Detector
overview" on page 4.42.
To open the trace menu
Press the TRACE key.
The trace menu is displayed. The Trace Configuration dialog box is displayed.
Menu and softkey description
– "Softkeys of the trace menu" on page 4.43
To display help to a softkey, press the HELP key and then the softkey for which you want to display
help. To close the help window, press the ESC key. For further information refer to section "How to use
the Help System".
Further information
– "Trace mode overview" on page 4.40
– "Detector overview" on page 4.42
– "Description of the averaging method" on page 4.41
– "ASCII file export format" on page 4.51
Task
– To specify the trace settings
To Next Page
Loading...
