Triggering the Sweep – TRIG Key R&S FSL
1300.2519.12 4.38 E-11
Video Pol Pos/Neg (zero span and option TV Trigger, B6)
Sets the polarity of the video signal. Default setting is Neg.
Positive video polarity is to be selected e.g. for standard L signals, negative video polarity for
signals according to the standards B/G/I/M (color standard PAL or NTSC).
Option TV Trigger, B6, is available from firmware version 1.10.
Remote: TRIG:VID:SSIG:POL NEG
Lines 625/525 (zero span and option TV Trigger, B6)
Sets the line system to be used. Default setting is 625 lines.
Option TV Trigger, B6, is available from firmware version 1.10.
Remote: TRIG:VID:FORM:LPFR 625
TV Free Run On/Off (zero span and option TV Trigger, B6)
Activates or deactivates the free run trigger mode for option TV Trigger, B6. For details on
trigger modes refer to "Trigger mode overview" on page 4.31. In this mode, only the trace modes
Clear Write and View are available (see also "Trace mode overview" on page 4.40).
This softkey is available from firmware version 1.30.
Remote: TRIG:VID:CONT ON
To Next Page
Loading...
