Rohde & Schwarz R&S FSL3 - Configure:btooth Subsystem (BLUETOOTH, K8)

R&S FSL CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.355 E-11
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
The following commands are used for configuration of the BLUETOOTH analyzer operating mode.
Commands of the CONFigure:BTOoth Subsystem
– CONFigure:BTOoth:ACLR:ACPairs
– CONFigure:BTOoth:BANDwidth|BWIDth[:RESolution]
– CONFigure:BTOoth:BANDwidth|BWIDth[:RESolution]:AUTO
– CONFigure:BTOoth:BANDwidth|BWIDth:VIDeo
– CONFigure:BTOoth:BANDwidth|BWIDth:VIDeo:AUTO
– CONFigure:BTOoth:CFSTability:BCOunt
– CONFigure:BTOoth:CHANnel
– CONFigure:BTOoth:DETector<1...6>[:FUNCtion]
– CONFigure:BTOoth:IBSemissions:ACPairs
– CONFigure:BTOoth:IBSemissions:GATE:AUTO
– CONFigure:BTOoth:MEASurement
– CONFigure:BTOoth:PBSCo
– CONFigure:BTOoth:PCLass
– CONFigure:BTOoth:POWer:AVERage:STARt
– CONFigure:BTOoth:POWer:AVERage:STOP
– CONFigure:BTOoth:PRATe
– CONFigure:BTOoth:PTYPe
– CONFigure:BTOoth:RTPower:DAVerage:STARt
– CONFigure:BTOoth:RTPower:DAVerage:STOP
– CONFigure:BTOoth:RTPower:GAVerage:STARt
– CONFigure:BTOoth:RTPower:GAVerage:STOP
– CONFigure:BTOoth:SWEep:COUNt
– CONFigure:BTOoth:SWEep:TIME
– CONFigure:BTOoth:SWEep:TIME:AUTO
– CONFigure:BTOoth:TRACe<1...6>:MODE
– CONFigure:BTOoth:TRACe<1...6>:SELect