R&S FSL CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1300.2519.12 6.357 E-11
CONFigure:BTOoth:BANDwidth|BWIDth[:RESolution]:AUTO
This command couples the resolution bandwidth to the settings according to the RF Test
Specification.
Note: The settings for the measurements of Modulation Characteristics, Initial Carrier
F
requency Tolerance, and Carrier Frequency Drift are common to all three
measurements.
For all other Bluetooth measurements the setting is only valid for the currently active
measurement (see CONFigure:BTOoth:MEASurement command).
Parameter
ON | OFF
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:BAND:AUTO ON
Activates the RBW coupling.
Characteristics
*RST value: ON
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:BANDwidth|BWIDth:VIDeo
This command sets the video bandwidth for the Adjacent Channel Power measurement (see
CONFigure:BTOoth:MEASurement command).
The available filters have a bandwidth range of 1 Hz to 10 MHz. On a change in video
bandwidth its link according to the RF Test Specification is switched off.
Note: This setting is only available for Output Power measurements.
Parameter
1 Hz to 10 MHz
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
CONF:BTO:BAND:VID 100HZ
Sets the video bandwidth to 100 Hz.
Characteristics
*RST value: – (AUTO is set to ON)
SCPI: device–specific
Mode
BT
To Next Page
Loading...
