CONFigure:BTOoth Subsystem (BLUETOOTH, K8) R&S FSL
1300.2519.12 6.356 E-11
C
ONFigure:BTOoth:ACLR:ACPairs
This command selects the number of adjacent channel pairs during the Adjacent Channel
Power measurement. The number of adjacent channels will be limited as soon as the border of
the Bluetooth frequency band is reached.
Note: This command is only available with active Adjacent Channel Power measurement (see
CONFigure:BTOoth:MEASurement command).
Parameter
1 to 78
Example
CONF:BTO:ACLR:ACP 10
Selects 10 adjacent channel pairs.
Characteristics
*RST value: 78
SCPI: device–specific
Mode
BT
CONFigure:BTOoth:BANDwidth|BWIDth[:RESolution]
This command sets the resolution bandwidth of the analyzer for the currently selected Bluetooth
measurement (see [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution] command).
For the measurements of modulation characteristics, initial carrier frequency tolerance, and
carrier frequency drift (CONFigure:BTOoth:MEASurement), the resolution bandwidth
corresponds to the IF bandwidth of the signal. If the resolution bandwidth is changed, its
coupling to the settings according to the RF Test Specification is cancelled.
Note: The settings for the measurements are valid for all three measurements.
For all other Bluetooth measurements the setting is only valid for the currently active
measurement (see CONFigure:BTOoth:MEASurement command).
This command is not available with active Adjacent Channel Power measurement.
Parameter
300kHz to 10MHz
Example
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:BAND 1KHZ
Sets the resolution bandwidth to 1kHz.
Characteristics
*RST value: – (AUTO is set to ON)
SCPI: device–specific
Mode
BT
To Next Page
Loading...
