Rohde & Schwarz R&S FSL3 - Display Subsystem (Noise Figure, K30)

DISPlay Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.534 E-11
DISPlay Subsystem (Noise Figure, K30)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
Commands of the DISPlay Subsystem
– DISPlay:ARRay:MEMory<1...3>[:STATe]
– DISPlay:CURRent:DATA[:STATe]
– DISPlay:DATA:TRACe<1>
– DISPlay:FORMat
– DISPlay[:WINDow<1>]:TABLe
– DISPlay[:WINDow<1>]:TRACe<1|2>[:STATe]
– DISPlay[:WINDow<1>]:TRACe<1|2>:SYMBols
– DISPlay[:WINDow<1>]:TRACe<1|2>:X[:SCALe]
– DISPlay[:WINDow<1>]:TRACe<1|2>:Y[:SCALe]:AUTO
– DISPlay[:WINDow<1>]:TRACe<1|2>:Y[:SCALe]:BOTTom
– DISPlay[:WINDow<1>]:TRACe<1|2>:Y[:SCALe]:RLEVel
– DISPlay[:WINDow<1>]:TRACe<1|2>:Y[:SCALe]:RLEVel:AUTO
– DISPlay[:WINDow<1>]:TRACe<1|2>:Y[:SCALe]:TOP
DISPlay:ARRay:MEMory<1...3>[:STATe]
This command switches the display of trace memory <n> on or off.
This command is available from firmware version 1.60.
Parameter
ON | OFF
Example
DISP:ARR:MEM2 ON
Switches on the display of memory 2.
Characteristics
RST value: OFF
SCPI: device–specific
Mode
NF