R&S FSL CONFigure Subsystem (Noise Figure, K30)
1300.2519.12 6.533 E-11
CONFigure:LIST:CONTinuous
This command configures for a frequency list measurement in continuous sweep mode.
This command is an event and therefore has no *RST value and no query.
Example
CONF:LIST:CONT
Configures to run a frequency list measurement in continuous sweep mode.
INIT
Starts a new measurement, if no measurement sequence is already in progress.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF
CONFigure:LIST:SINGle
This command configures for a frequency list measurement in single sweep mode.
This command is an event and therefore has no *RST value and no query.
Example
CONF:LIST:SING
Configures to run frequency list measurement in single sweep modes.
INIT
Starts a new measurement, if no measurement sequence is already in progress.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF
CONFigure:SINGle
This command configures for a fixed frequency measurement.
This command is an event and therefore has no *RST value and no query.
Example
CONF:SING
Configures to run fixed frequency measurements.
INIT
Starts a new measurement, if no measurement sequence is already in progress.
Characteristics
*RST value: –
SCPI: device–specific
Mode
NF
To Next Page
Loading...
