Rohde & Schwarz R&S FSL3 - Measurement Documentation - PRINT Key

Measurement Documentation - PRINT Key R&S FSL
1300.2519.12 4.520 E-11
Measurement Documentation - PRINT Key
The PRINT key is used to select and configure the printer and to customize the screen printout. For
detailed information on printer selection and installation refer to the Quick Start Guide.
To open the print menu
 Press the PRINT key.
The print menu is displayed.
Menu and softkey description
– "Softkeys of the print menu" on page 4.520
To display help to a softkey, press the HELP key and then softkey for which you want to display help.
To close the help window, press the ESC key. For further information refer to section "How to use the
Help System".
Softkeys of the print menu
The following table shows all softkeys available in the print menu. It is possible that your instrument
configuration does not provide all softkeys. If a softkey is only available with a special option, model or
(measurement) mode, this information is delivered in the corresponding softkey description.
Menu / Command Submenu / Command
Print Screen
Device Setup
Device 1/2
Colors Select Print Color Set
Color On/Off
Select Object
Predefined Colors
User Defined Colors
Set to Default
Comment
Install Printer
Print Screen
Starts to printout all test results displayed on the screen: diagrams, traces, markers, marker lists,
limit lines etc. Comments, title, date, and time are included at the bottom margin of the printout.
All displayed items belonging to the instrument software (softkeys, tables, dialog boxes) are not
printed out. The date and time can be excluded from the printout via the Device Setup softkey.
The output is defined via the Device Setup softkey. If the output is saved in a file, the file name
used in the last saving process is counted up to the next unused name. If you use a file name
that already exists, upon saving, a message is displayed. Selecting Yes overwrites the existing
file, selecting No aborts the saving process. For further details on the file name and an example,
refer to the file menu, Edit File Name softkey.