Saving and Recalling Settings Files - FILE Key R&S FSL
1300.2519.12 4.514 E-11
Edit File Name
Sets the focus on the File Name field.
I
n the Save dialog box, the field already contains a suggestion for a new name: the file name
used in the last saving process is counted up to the next unused name. For example, if the
name last used was "test_004", the new name "test_005" is suggested, but only if this name is
not in use. If the name "test_005" is already in use, the next free name is suggested, e.g.
"test_006". You can change the suggested name to any name conform to the following naming
conventions.
The name of a settings file consists of a base name followed by an underscore and three
numbers, e.g. limit_lines_005. In the example, the base name is "limit_lines". The base name
can contain characters, numbers and underscores. The file extension is added automatically.
This softkey is available from firmware version 1.70.
Edit Comment
Sets the focus on the Comment field to enter a comment for the settings file. Max. 60
characters are allowed. For details see also "Navigation in the dialog boxes for saving and
loading settings files" on page 4.511.
Select Items
Displays the softkey submenu for selecting the items to be stored or loaded.
Select Items
Sets the focus on the items list. For details see also "Navigation in the dialog boxes for saving
and loading settings files" on page 4.511.
In the Save dialog box, all items that can be saved are displayed. The number of displayed
items depends on the installed options, as for some options additional items can be stored.
In the Recall dialog box, the items saved in the selected file are displayed.
Remote: MMEM:SEL:HWS ON
Remote: MMEM:SEL:LIN:ALL ON
Remote: MMEM:SEL:TRAC ON
Remote: MMEM:SEL:TRAN:ALL ON
Enable all Items
Selects all items for saving or loading.
This softkey is available from firmware version 1.70.
Remote: MMEM:SEL:ALL
To Next Page
Loading...
