Rohde & Schwarz R&S FSL3 - Display Subsystem (WCDMA, K72)

R&S FSL DISPlay Subsystem (WCDMA, K72)
1300.2519.12 6.577 E-11
DISPlay Subsystem (WCDMA, K72)
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
Commands of the DISPlay Subsystem
– DISPlay[:WINDow<1|2>]:TRACe<1...6>[:STATe]
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:MODE
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:PDIVision
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel:OFFSet
– DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RPOSition
DISPlay[:WINDow<1|2>]:TRACe<1...6>[:STATe]
For details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>[:STATe]" on page 6.132.
DISPlay[:WINDow<1|2>]:TRACe<1...6>:MODE
Parameter
WRITe | VIEW | AVERage | MAXHold | MINHold
For details on trace modes refer to chapter "Instrument Functions", section "Trace mode
overview".
For further details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:MODE" on page 6.132.
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:PDIVision
This command defines the scaling of the y–axis in dB.
The numeric suffixes <1|2> and <1...6> are irrelevant.
Parameter
0.01 to 100 dB
Example
DISP:TRAC:Y:PDIV +10DB
Sets the Y scale to 10 dB/div.
Characteristics
*RST value: 7
SCPI: conform
Mode
WCDMA
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel
For details refer to "DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel" on page 6.135.