R&S FSL DISPlay Subsystem
1300.2519.12 6.135 E-11
D
ISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:MODE
This command defines the scale type of the y–axis (absolute or relative).
When SYSTem:DISPlay:UPDate is set to OFF, this command has no immediate effect on the
screen. The numeric suffixes <1|2> and <1...6> are irrelevant.
Parameter
ABSolute | RELative
Example
DISP:TRAC:Y:MODE REL
Characteristics
*RST value: ABS
SCPI: device–specific
Mode
all
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel
This command defines the reference level.
With the reference level offset <> 0, the indicated value range of the reference level is modified
by the offset.
The unit depends on the setting defined with CALCulate<1|2>:UNIT:POWer.
The numeric suffixes <1|2> and <1...6> are irrelevant.
Parameter
<numeric_value> in dBm, range specified in data sheet
Example
DISP:TRAC:Y:RLEV –60dBm
Characteristics
*RST value: –20dBm
SCPI: conform
Mode
A, CATV, CDMA, EVDO, WCDMA
DISPlay[:WINDow<1|2>]:TRACe<1...6>:Y[:SCALe]:RLEVel:OFFSet
This command defines the offset of the reference level.
The numeric suffixes <1|2> and <1...6> are irrelevant.
Parameter
–200dB to 200dB
Example
DISP:TRAC:Y:RLEV:OFFS –10dB
To Next Page
Loading...
