Rohde & Schwarz R&S FSL3 - Sense Subsystem (Noise Figure, K30)

SENSe Subsystem (Noise Figure, K30) R&S FSL
1300.2519.12 6.548 E-11
SENSe Subsystem (Noise Figure, K30)
The SENSe subsystem is used to set and query the values of parameters in the remote instrument.
:DEFault If a parameter has a default a value, the command parameter can be substituted with
:DEFault which loads the default (reset) value of the parameter.
:UP/DOWN In addition, all numeric values are able to take :UP or :DOWN in place of the
parameter. This will increment or decrement the numeric value.
:MIN/MAX In addition, all numeric values are able to take either :MINimum or :MAXimum as
arguments to determine the minimum or maximum range available for the command.
The SENSe subsystem is divided into equipment settings and measurement settings:
• "Equipment Settings" on page 6.548
• "Measurement Settings" on page 6.554
Equipment Settings
Commands of the equipment settings
– [SENSe:]CORRection[:STATe]
– [SENSe:]CORRection:ENR:MODE
– [SENSe:]CORRection:ENR:SPOT
– [SENSe:]CORRection:ENR[:MEASurement]:TABLe:DATA
– [SENSe:]CORRection:IREJection
– [SENSe:]CORRection:LOSS:INPut:MODE
– [SENSe:]CORRection:LOSS:INPut:SPOT
– [SENSe:]CORRection:LOSS:INPut:TABLe
– [SENSe:]CORRection:LOSS:OUTPut:MODE
– [SENSe:]CORRection:LOSS:OUTPut:SPOT
– [SENSe:]CORRection:LOSS:OUTPut:TABLe
– [SENSe:]CORRection:TEMPerature
[SENSe:]CORRection[:STATe]
This command activates or deactivates the second stage correction.
Parameter
ON | OFF
Example
CORR ON
Activates the second stage correction.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
NF