R&S FSL UNIT Subsystem (CATV, K20)
1300.2519.12 6.521 E-11
Remote Commands of the Noise Figure
Measurements Option (K30)
This section describes the remote commands for the Noise Figure Measurements option (K30). The
abbreviation NF stands for the operating mode of noise figure measurements. For details on
conventions used in this chapter refer to section "Notation" on page 6.2 at the beginning of this chapter.
For further information on analyzer or basic settings commands, refer to the corresponding subsystem
in section "Remote Commands of the Base Unit" on page 6.5.
This option is available from firmware version 1.50.
Subsystems of the Noise Figure Measurements option (K30)
– "ABORt Subsystem (Noise Figure, K30)" on page 6.522
– "CALCulate Subsystem (Noise Figure, K30)" on page 6.523
– "CONFigure Subsystem (Noise Figure, K30)" on page 6.532
– "DISPlay Subsystem (Noise Figure, K30)" on page 6.534
– "FETCh Subsystem (Noise Figure, K30)" on page 6.541
– "INITiate Subsystem (Noise Figure, K30)" on page 6.545
– "INPut Subsystem (Noise Figure, K30)" on page 6.546
– "INSTrument Subsystem (Noise Figure, K30)" on page 6.547
– "SENSe Subsystem (Noise Figure, K30)" on page 6.548
– "STATus Subsystem (Noise Figure, K30)" on page 6.558
– "SYSTem Subsystem (Noise Figure, K30)" on page 6.563
To Next Page
Loading...
