Rohde & Schwarz R&S FSL3 - Trigger Subsystem (CATV, K20)

R&S FSL TRIGger Subsystem (CATV, K20)
1300.2519.12 6.517 E-11
TRIGger Subsystem (CATV, K20)
The TRIGger subsystem is used to synchronize instrument actions with events. It is thus possible to control
and synchronize the start of a sweep.
Commands of the TRIGger Subsystem
– TRIGger<1|2>[:SEQuence]:HOLDoff[:TIME]
– TRIGger<1|2>[:SEQuence]:VIDeo:BFIeld[:NUMBer]
– TRIGger<1|2>[:SEQuence]:VIDeo:BLINe[:NUMBer]
– TRIGger<1|2>[:SEQuence]:VIDeo:BLINe:TYPE
– TRIGger<1|2>[:SEQuence]:VIDeo:FIELd:[NUMBer]
– TRIGger<1|2>[:SEQuence]:VIDeo:LINE:[NUMBer]
– TRIGger<1|2>[:SEQuence]:VIDeo:QFIeld[:NUMBer]
– TRIGger<1|2>[:SEQuence]:VIDeo:QLINe[:NUMBer]
TRIGger<1|2>[:SEQuence]:HOLDoff[:TIME]
For details refer to "TRIGger<1|2>[:SEQuence]:HOLDoff[:TIME]" on page 6.277.
TRIGger<1|2>[:SEQuence]:VIDeo:BFIeld[:NUMBer]
This command sets the bar field parameter for analog TV measurements.
Parameter
1 | 2
Example
TRIG:VID:BFI 2
Sets the bar field parameter to 2.
Characteristics
RST value: 1
SCPI: device–specific
Mode
CATV
TRIGger<1|2>[:SEQuence]:VIDeo:BLINe[:NUMBer]
This command sets the bar line parameter for analog TV measurements.
Parameter
<numeric_value>
Example
TRIG:VID:BLIN 16
Sets the bar line parameter to 16.