Rohde & Schwarz R&S FSL3 - Configure Subsystem (WLAN, K91; K91 N)

CONFigure Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.698 E-11
CONFigure Subsystem (WLAN, K91 / K91n)
The CONFigure subsystem contains commands for configuring complex measurement tasks. The
CONFigure subsystem is closely linked to the functions of the FETCH subsystem, where the
measurement results are queried.
Commands of the CONFigure Subsystem
– CONFigure:BURSt:CONSt:CARRier:SELect
– CONFigure:BURSt:CONSt:CCARrier[:IMMediate]
– CONFigure:BURSt:CONSt:CSYMbol[:IMMediate]
– CONFigure:BURSt:EVM:ECARrier[:IMMediate]
– CONFigure:BURSt:EVM:ESYMbol[:IMMediate]
– CONFigure:BURSt:PREamble[:IMMediate]
– CONFigure:BURSt:PREamble:SELect
– CONFigure:BURSt:PVT[:IMMediate]
– CONFigure:BURSt:PVT:AVERage
– CONFigure:BURSt:PVT:RPOWer
– CONFigure:BURSt:PVT:SELect
– CONFigure:BURSt:SPECtrum:ACPR[:IMMediate]
– CONFigure:BURSt:SPECtrum:FFT[:IMMediate]
– CONFigure:BURSt:SPECtrum:FLATness[:IMMediate]
– CONFigure:BURSt:SPECtrum:MASK[:IMMediate]
– CONFigure:BURSt:SPECtrum:MASK:SELect
– CONFigure:BURSt:STATistics:BSTReam[:IMMediate]
– CONFigure:BURSt:STATistics:CCDF[:IMMediate]
– CONFigure:BURSt:STATistics:SFIeld[:IMMediate]
– CONFigure:CHANnel
– CONFigure:POWer:AUTO
– CONFigure:POWer:AUTO:SWEep:TIME
– CONFigure:POWer:EXPected:RF
– CONFigure:STANdard
CONFigure:BURSt:CONSt:CARRier:SELect
This remote control command is only available when Constellation vs Symbol measurement is
selected. When the Constellation versus Symbol measurement is initiated, it will calculate the
results of the selected carrier.
Parameter
–26 to 26 | ALL | PILOTS