R&S FSL CONFigure Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.703 E-11
C
ONFigure:BURSt:SPECtrum:ACPR[:IMMediate]
This remote control command configures the measurement type to be ACPR (adjacent channel
power relative) After this command has been executed, the specified measurement will only be
started when the user issues the INITiate[:IMMediate] command.
Example
CONF:BURS:SPEC:ACPR
Configures the ACPR measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:SPECtrum:FFT[:IMMediate]
This remote control command configures the measurement type to be FFT (Fast Fourier
Transform). After this command has been executed, the specified measurement will only be
started when the user issues the INITiate[:IMMediate] command.
Example
CONF:BURS:SPEC:FFT
Configures the FFT measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:SPECtrum:FLATness[:IMMediate]
This remote control command configures the measurement type to be Spectrum Flatness. After
this command has been executed, the specified measurement will only be started when the
user issues the INITiate[:IMMediate] command.
Example
CONF:BURS:SPEC:FLAT
Configures the Spectrum Flatness measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
