CONFigure Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.704 E-11
CONFigure:BURSt:SPECtrum:MASK[:IMMediate]
This remote control command configures the measurement type to be Spectrum Mask. After
this command has been executed, the specified measurement will only be started when the
user issues the INITiate[:IMMediate] command
Example
CONF:BURS:SPEC:MASK
Configures the Spectrum Mask measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:SPECtrum:MASK:SELect
This remote control configures the interpretation of the Spectrum Mask measurement results.
This command is only available for IEEE 802.11a.
Parameter
IEEE | ETSI
Example
CONF:BURS:SPEC:MASK:SEL ETSI
Interprets the measurement results using the ETSI standard.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:STATistics:BSTReam[:IMMediate]
This remote control command configures the measurement type to be Bitstream. After this
command has been executed, the specified measurement will only be started when the user
issues the INITiate[:IMMediate] command.
Example
CONF:BURS:STAT:BSTR
Configures the Bitstream measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
