R&S FSL CONFigure Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.705 E-11
CONFigure:BURSt:STATistics:CCDF[:IMMediate]
This remote control command configures the measurement type to be CCDF (conditional
cumulative distribution functions.). After this command has been executed, the specified
measurement will only be started when the user issues the INITiate[:IMMediate]
command.
Example
CONF:BURS:STAT:CCDF
Configures the CCDF measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:STATistics:SFIeld[:IMMediate]
This remote control command configures the measurement type to be Signal Field. After this
command has been executed, the specified measurement will only be started when the user
issues the INITiate[:IMMediate] command.
Example
CONF:BURS:STAT:SFIeld
Configures the Signal Field measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:CHANnel
This remote control command is used to specify the input channel for which measurements are
to be performed. This command will automatically cause the internal measurement frequency to
be re–calculated.
Parameter
<numeric_value>
Example
CONF:CHAN 9
Specifies channel 9 as frequency measurement.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
