Rohde & Schwarz R&S FSL3 - Display Subsystem (Wimax, K92;K93)

R&S FSL DISPlay Subsystem (WiMAX, K92/K93)
1300.2519.12 6.811 E-11
DISPlay Subsystem (WiMAX, K92/K93)
The DISPlay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display. In contrast to the base unit, the WiMAX IEEE 802.16
OFDM, OFDMA Measurements option supports the split screen modus.
Commands of the DISPlay Subsystem
– DISPlay:FORMat
– DISPlay[:WINDow<1|2>]:SELect
– DISPlay[:WINDow<1|2>]:SSELect
– DISPlay[:WINDow<1|2>]:TABLe
– DISPlay[:WINDow<1|2>]:TABLe:UNIT
– DISPlay[:WINDow<1|2>]:TRACe1:Y[:SCALe]:AUTO
– DISPlay[:WINDow<1|2>]:TRACe1:Y[:SCALe]:PDIVision
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:RLEVel[:RF]
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:RLEVel?
– DISPlay[:WINDow<1|2>]:TRACe<1…3>:Y[:SCALe]:RLEVel:OFFSet
DISPlay:FORMat
This command sets the screen display type to full or split screen.
Parameter
SPLit | SINGle
Example
DISP:FORM SING
Sets the display to full screen.
Characteristics
RST value: SPLit
SCPI: device–specific
Mode
OFDM, OFDMA/WiBro
DISPlay[:WINDow<1|2>]:SELect
This command selects whether screen A or screen B is active (see also
DISPlay[:WINDow<1|2>]:SSELect)
Example
DISP:WIND1 SEL
Sets screen A active.
Characteristics
RST value: –
SCPI: device–specific
Mode
OFDMA/WiBro