Rohde & Schwarz R&S FSL3 - Page 1572

R&S FSL DISPlay Subsystem (WiMAX, K92/K93)
1300.2519.12 6.813 E-11
DISPlay[:WINDow<1|2>]:TRACe1:Y[:SCALe]:AUTO
This command switches on or off automatic scaling of the y–axis for trace 1. If switched on, the
y–axis is scaled to best fit the measurement results automatically.
The numeric suffix <1|2> defines the active window.
This command is only available for the following result displays:
– EVM vs Carrier
– EVM vs Symbol
Parameter
ON | OFF
Example
DISP:WIND2:TRAC1:Y:AUTO ON
Switches on automatic scaling of the y–axis for the active trace.
Characteristics
RST value: ON
SCPI: conform
Mode
OFDM, OFDMA/WiBro
DISPlay[:WINDow<1|2>]:TRACe1:Y[:SCALe]:PDIVision
This command sets the size of each y scale division for trace 1. It has no affect if automatic
scaling of the y–axis is enabled.
The numeric suffix <1|2> defines the active window.
This command is only available for the following result displays:
– EVM vs Carrier
– EVM vs Symbol
Parameter
1E–6 to 10E12
Example
DISP:WIND2:TRAC1:Y:AUTO OFF
Switches off automatic scaling of the y–axis for the active trace.
DISP:WIND2:TRAC1:Y:PDIV 2
Sets the y scale division to size 2.
Characteristics
RST value: 3
SCPI: conform
Mode
OFDM, OFDMA/WiBro