CONFigure Subsystem (WLAN, K91 / K91n) R&S FSL
1300.2519.12 6.702 E-11
CONFigure:BURSt:PVT:RPOWer
This remote control command configures the use of either mean or maximum burst power as a
reference power for the 802.11b PVT measurement.
Parameter
MEAN | MAXimum
Example
CONF:BURS:PVT:RPOW MEAN
Configures to use mean burst power as a reference power.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:PVT:SELect
This remote control configures how to interpret the Power vs Time measurement results.
Parameter Description Wireless LAN standard
EDGE configures the measurement to be
rising and falling edge
all
FALL configures the measurement to be
falling edge only
IEEE 802.11b & g (CCK)
FULL configures the measurement to be full
burst
IEEE 802.11a, j & g, n (OFDM),
IEEE 802.11 Turbo Mode
RISE configures the measurement to be
rising edge only
IEEE 802.11b & g (CCK)
Example
CONF:BURS:PVT:SEL FULL
Interprets the measurement results as full burst
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
