R&S FSL CONFigure Subsystem (WLAN, K91 / K91n)
1300.2519.12 6.701 E-11
C
ONFigure:BURSt:PREamble:SELect
This remote control command configures the interpretation of the preamble measurement
results.
Parameter
PHASe | FREQuency
Example
CONF:BURS:PRE:SEL PHAS
Configures the Phase vs Preamble measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:PVT[:IMMediate]
This remote control command configures the measurement type to be Power vs Time. After this
command has been executed, the specified measurement will only be started when the user
issues the INITiate[:IMMediate] command.
Example
CONF:BURS:PVT
Configures the Power vs Time measurement type.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
CONFigure:BURSt:PVT:AVERage
This remote control command configures the measurement type to set the burst power
averaging length to the desired value. This command is only valid when the selected standard is
IEEE 802.11b.
Parameter
<numeric_value>
Example
CONF:BURS:PVT:AVER 31
Configures the burst power average length of 31.
Characteristics
*RST value: –
SCPI: device–specific
Mode
WLAN
To Next Page
Loading...
